Testing Resistor

Mostly when a resistor spoilt they either increase in resistance value or open up at all. You may check the resistance of a resistor with an ohmmeter or multimeter. If the resistor is in the circuit, you will  have to remove the resistor so you are measuring only the resistor, not other components in the circuit. Always be aware of possible back( parallel) circuits when performing in-circuit resistance test. 
As a technician, most of the times we want to repair and solve problems as fast as possible thus removing all resistors from the board and check the resistors one by one will take up a lot of our time. There have to be an easy way to check resistor on board.  Using analog meter to check resistor on board often produced a wrong reading. This is due to the reason that the output from the analog meter is from 3v to 12 volt. The voltages are quite high and it can trigger the semiconductor devices around the resistors such as diode, transistor and ICs. Do you know that semiconductors only need voltage of 0.6v in order to conduct. Since the output voltage from the analog meter is higher than the semiconductors, measuring the resistor in circuit won't give you an accurate reading!
In order to check resistors while it still in circuit, you need to get a good digital multimeter that have the output of less than 0.6v. This is to avoid conducting the semiconductor devices around the circuit that you want to check. Currently i' m using the Greenlee digital meter that have output around 0.2volt. Though it cannot give me a 100% accurate result at least it can help me to speed up my repair job. Why not 100% accurate? This is due to that some circuit have resistors that is directly parallel to each other. 
 
If you connect your digital meter leads across a resistor in a circuit and it measures higher than it should be,
then you know that the resistor is either open or has gone up in resistance value. Other circuit components cannot possibly increase the resistance value of a resistor; any parallel circuit could only make the resistance reading lower. In rare cases, sometimes an undischarge capacitor can cause the reading higher than it should be. Only through more practice or repair works will make you know when you should remove the resistors and check it off board. Hope this article will help you to speed up your troubleshooting job.